MASTER FEED SECTION
SM 3-53 C262/C265
Replacement
Adjustment
3.7.20 MASTER MAKING UNIT PARALLEL ADJUSTMENT
Purpose: To make sure that the master is correctly wrapped around the drum
without skew.
1. Make a new master. The machine will wrap this master around the drum.
2. Take out the drum unit from the machine.
3. Measure the clearance at the leading edge [A] and the trailing edge [B]
between the edge of the master [C] and the edge of the metal screen [D].
NOTE: Standard for A4 drums, A3 drums, and DLT drums: 32.0 mm
4. Remove the master making unit ( 3.7.1).
C262R200.WMF
C262R197.WMF
Non-operation side
[B]
[C]
[D]
[A]
[E]
To Next Page
Loading...
