DRUM
C262/C265 6-64 SM
Automatic Ink Supply for a New Drum
If the machine detects a new drum, ink is supplied automatically at the trial print for
the first job with this drum.
The machine detects a new drum if:
• There is no master wrapped on the drum, and
• The ink detection pins detect no ink
The process is as follows.
1. Set an original.
2. Push the Start button.
3. The drum rotates.
4. The machine detects a new drum
5. Ink is supplied automatically.
6. If the machine detects the ink before 26 seconds, go to step 8.
If the machine does not detect the ink before 26 seconds, go to step 7.
7. A blank master is wrapped around the drum, and the drum and pressure
cylinder rotate, with pressure applied to the drum. Then the blank master is
removed. Go to step 8.
8. Master making is started for the original that you set.
NOTE: There is also a manual ink supply procedure, like for previous machines.
“0” + “Economy Mode”
Procedure:
1. Press the “Master Making” key to light the Master Making indicator.
2. On the screen, push ‘Make Master Options’.
3. Hold down the ‘0’ key, and at the same time push ‘Economy Mode
Level 1’ or ‘Economy Mode Level 2’.
To Next Page
Loading...
