PRINTING AND PRESSURE CYLINDER
C262/C265 6-110 SM
The print pressure for each setting in the above table can be adjusted with SP6-54
~ SP6-58 (print pressure). Also, you can change all settings at the same time by
the same amount with SP2-6-18 (print pressure shift amount).
If you do not want the pressure to change with print speed and temperature, set SP
2-6-16 to ‘on’. Then the pressure will always be the same as the value that is set
with SP 2-6-17.
CAUTION: If the pressure is too high, the master will become wrinkled.
Auto cycle printing, from master making
After the power is turned on or after the machine leaves energy saver mode, the
print pressure adjustment mechanism is adjusted for the current temperature
conditions. The adjustment is done when the machine detects that the drum is at
home position.
Then at the start of master making, the print pressure adjustment mechanism is
adjusted again. As a result, when the pressure is applied between drum and
pressure cylinder at the start of printing, the correct pressure for the current
conditions will be immediately applied.
The pressure for the 1
st
print is applied after the trial print is fed out.
After the first print, the print pressure depends on the print speed setting.
Only master making
Same as the first two paragraphs of ‘Auto cycle printing, from master making’.
Only printing
The pressure for the 1
st
print is applied after the trial print is fed out.
After the first print, the print pressure depends on the print speed setting.
To Next Page
Loading...
