PAPER FEED SECTION
C262/C265 3-90 SM
3.9.9 FRICTION PADS
• Pick-up roller, Paper feed roller ( 3.9.2)
[A]: Friction pad
NOTE:
1) Friction pad A is the standard friction pad. It is black.
Friction pad B is the ‘special’ friction pad. It is grey.
If you cannot see the correct friction pad at [A] as shown above, use
SP 5-42 to move the necessary pad to [A].
To move friction pad A to the replacement position, turn on the main
switch, then access SP 5-42-1, and push the Start key.
To move friction pad B to the replacement position, turn on the main
switch, then access SP 5-42-2, and push the Start key.
2) After you install a new friction pad, reset the PM counter:
• Friction pad A: SP3-4-5
• Friction pad B: SP3-4-6
C262R192.WMF
[A]
To Next Page
Loading...
