Ricoh LDD280 - Sliding Arm Control

PAPER DELIVERY
C262/C265 6-120 SM
Sliding Arm Control
The sliding arm moves across until the slider position sensor [B] (a micro-switch)
tuns on. When the sliding arm returns, the job separation motor turns until the
slider HP sensor [C] (a micro-switch) turns on.
While the sliding arm is being lowered onto the top sheet of the paper stack, the
paper sensor [D] (a micro-switch) turns on when the edge of the sliding arm
touches the paper.
The slider upper limit sensor [A] detects when the sliding arm is at its highest
possible position.
C262D119.WMF
[A]
[B]
[C]
[D]