PAPER DELIVERY SECTION
SM 3-155 C262/C265
Replacement
Adjustment
3.12.6 PAPER EXIT PAWL DRIVE TIMING ADJUSTMENT
Purpose: To ensure smooth feed, and to ensure that the exit pawl does not touch
the master clamper on the drum.
NOTE: You must adjust this after the main drive belt or the main motor is replaced.
• Drum unit ( 3.8.1)
• Paper delivery unit ( 3.12.2)
1. Make sure that the drum drive disk is in the home position.
NOTE: Normally, the disk is in the home position after the drum is removed. If
necessary, set the drum securing tool [A] to make sure that the drum
drive disk is in the home position. (If the special tool is not available,
align the long positioning hole in the drum drive disk exactly with the
shaft [C] below it as shown.)
2. Make sure that the positioning holes in the rear frame and the drive gear [B] are
in line as shown [C].
3. If the holes are in line, the paper exit pawl drive timing is OK. If they are not,
remove the gear [B] and reinstall it so that the holes are in line.
C262R124.WMF
[A]
[B]
[C]
To Next Page
Loading...
