PRINTING AND PRESSURE CYLINDER
SM 6-101 C262/C265
Detailed
Descriptions
6.9.2 PRESSURE CYLINDER
To stabilize the image density and print registration, and to decrease noise during
printing, the pressure cylinder [A] has the same diameter as the drum (diameter
180 mm and 300 mm in circumference).
The paper clamper [B] is on the outer surface of the pressure cylinder, and the
encoder plate [C] for monitoring the speed of rotation is on the rear of the pressure
cylinder. The actuators for the feed start timing sensor are also on the rear of the
cylinder ( 6.8.2).
NOTE:
1) Do not damage the surface of the pressure cylinder. The surface is soft
and easily damaged by impacts.
2) Do not clean the pressure cylinder surface with alcohol or other strong
solvents. Use a cloth dampened with water. Periodic cleaning is required
for this part.
C262D097.WMF
[A]
[B]
[C]
To Next Page
Loading...
