Ricoh LDD280 - Feed Encoder, Feed Start Sensor, Feed Encoder Harness, Feed Encoder Cleaning Brush

PRINTING SECTION
SM 3-107 C262/C265
Replacement
Adjustment
3.10.2 FEED ENCODER, FEED START SENSOR, FEED ENCODER
HARNESS, FEED ENCODER CLEANING BRUSH
• Drum unit ( 3.8.1)
• Rear cover ( 3.2.2)
• Open out the ACU - ECU assembly ( 3.5.1)
1. Disconnect the connector [A] from the rear of the machine (1 clamp [B]).
[C]: Knob cover ( x 1)
2. Turn the knob [C] until the flat part of the cylinder [D] is in the position shown.
C262R097.WMF
C262R098.WMF
[B]
[A]
[C]
[D]