PRINTING SECTION
C262/C265 3-106 SM
6. While the round hole [F] is uppermost, push the pressure cylinder towards the
non-operation side (to engage the join behind the cylinder).
NOTE:
1) If it cannot enter, push while turning the pressure cylinder a little.
Check if the joint is engaged properly by turning the pressure
cylinder slightly.
2) Set the bearing stopper [G] as shown.
7. Install the white cam [H] as shown.
8. Reassemble the machine.
After you install a new paper clamper, reset the counter for this part with SP 3-4-2.
C262R111.WMF
C262R107.WMF
[F]
[G]
[H]
To Next Page
Loading...
