Ricoh LDD280 - Master cut error; Master clamp error

MASTER FEED
SM 6-57 C262/C265
Detailed
Descriptions
Master cut error
1st Drum Position Sensor
2nd Drum Position Sensor
Master Edge Sensor
Cutter HP Sensor
Main Motor
Cutter Motor
Master set sensor stays on when master cut error
occur, and remaining of master will be cut.
The master cut error is detected by
master edge sensor
OFF: Cut error (jam)
ON: Service Call
Cut after error
This is for when the master could not be cut at first trial
SC 300 (Main motor lock) occurs if the master is not cut after several attempts after
master making.
Master clamp error
2nd Drum Position Sensor
2nd Drum Master Sensor
Clamper Position
67.24 degrees
Check 2nd drum master senosr
（
50ms
）
OFF: Master clamp error
The drum master sensor detects if the drum clamper has clamped the master.