PAPER FEED SECTION
C262/C265 3-94 SM
[H]: Bearing holder ( x 2)
[I]: Bearing
[J]: Lower registration roller
NOTE: Slide the lower registration roller [J] towards the operation side.
3.9.13 REGISTRATION ROLLER LIFTING CAM POSITION
ADJUSTMENT
Purpose: To ensure smooth paper feed from the registration roller to the drum.
NOTE: Make sure that the drum is at home position before the adjustment.
1. When installing the registration roller lifting cam [A] on the shaft, align the cam
follower (a bushing) at the center or within one division to the right of the center.
2. If the cam follower cannot be put in the correct place, try to change the gear
meshing. Also, try to readjust the position by loosing the screw holding the cam
to the gear.
NOTE: To obtain a perfect adjustment, you must take out any gear play by
applying clockwise pressure to the cam (with the gear) during the
adjustment.
C262R092.WMF
[A]
To Next Page
Loading...
