Ricoh LDD280 - 3. System Settings

SERVICE PROGRAM MODE
C262/C265 5-26 SM
3. System Settings
No. Display
No
.
Menu Function Default Setting
1
Serial Number
-
6
Phone Number - Service
7
Phone Number - Supply
Order
8
Phone Number –
Business
9
Product Name - Master
10
Product Name – Ink
11
Date
12
Installation Date
-
3-1
Installation
Setting
13
First Power On Date
Use these to input the
serial numbers, etc.
Do these at installation if
required. The data is
used in the data printout
mode in the system test.
(SP3-1-1 can be seen in
SP1-21-1. SP3-1-6 can
be seen in SP1-22-1.)
-
1
Set Job Separation
Yes No/Yes
2
Set Key Counter
No No/Yes
3
Optional Counter Type
Set to Yes if installed. 0
0: None
1:
Add.card
2:
Sub.crd
3:
Prepaid
Card
4: Coin
Rack
4
Set Paper Delivery Table
Japan only No No/Yes
5
Set Paper Feed Station
No No/Yes
6
Set Sorter
Japan only No No/Yes
7
Set Two-table Delivery
Unit
Japan only No No/Yes
10
Double Feed Sensor Set to ‘No’ if a
customer’s paper type
causes problems with
the double feed sensor.
Yes No/Yes
11
LCIT
Set to Yes if installed. No No/Yes
12
LCOT
Set to Yes if installed. No No/Yes
13
Original Back Light
Japan only No No/Yes
3-2 Unit Setting
14
Anti-Condensation
Heater
Japan only No No/Yes
3-4 1
Drum Screen
2
Paper Clamper Unit
PM Parts
Replacement
Record
3
Feed Pressure
4
Separation Pressure
5
Friction Pad A
6
Friction Pad B
7
Brush Velt.
See Note 1.
8
Bank Feed Pressure
9
Bank Separation
Pressure
10
Bank Friction Pad