PAPER FEED SECTION
C262/C265 3-100 SM
Paper Clamping Timing Adjustment
PURPOSE:
To ensure that the paper reaches the paper clamper on the pressure
cylinder properly. Changing the paper clamping timing with SP6-027 to
29 changes the paper feed length for the paper registration roller.
CAUTION: Do not change SP6-020 to 6-024 (these change the registration
motor start timing). In addition, do not change SP6-031-1, -4, -5, or -
6.
PROCEDURE:
1. Turn on the main switch, then access the SP mode.
2. Enter SP6-027-1 to 8 (Paper Clamp Timing Pulse).
NOTE: The paper clamping timing depends on the paper type selected at the
operation panel, and the print speed. SP6-027-1 to 8 are the
adjustment for normal paper only. For thick paper, use SP6-028-1 to 8.
3. Increase or decrease the value on the display.
NOTE:
1) Before changing the value, check the current setting, in case you
need to recover the previous setting.
2) Changing the value by +1 decreases the registration motor's on-
time and feeds the paper 0.3 mm less.
4. Leave the SP mode, then check the paper feed performance. If the problem still
occurs, repeat the above steps.
To Next Page
Loading...
