PAPER FEED SECTION
SM 3-97 C262/C265
Replacement
Adjustment
3.9.16 TIMING BELT TENSION ADJUSTMENT FOR THE
REGISTRATION MOTOR
Purpose: To ensure smooth paper feed.
1. Make sure that the distance between the end of the lower registration roller
shaft and the edge of the pulley is 0 ± 0.5 mm.
2. Apply a 500g load to the center of the belt using a tension gauge. Make sure
that the belt deflects between 2 to 4 mm. If the tension is correct, move the
motor up or down.
C262R096.WMF
2 to 4 mm
0 ± 0.5 mm
To Next Page
Loading...
