Ricoh LDD280 - Adjustable Buffer Fins

PAPER DELIVERY
C262/C265 6-118 SM
6.10.5 ADJUSTABLE BUFFER FINS
The printed paper bends upwards easily. This causes uneven stacking and ink
stains on the back of the paper on the delivery table. The buffer fins [A] on the
paper delivery table [B] lift the edges of the paper, to prevent this problem. When
the paper is fed to the delivery table, these plates catch the edges of the paper,
and the paper falls in a “U” shape, as shown in the diagram, with a gap between
each sheet. The plates catching the edges also make the paper fall more slowly,
and the ink dries before the paper reaches the stack.
The following table shows the recommended positions for these plates (and for the
paper guide wings) for each paper type.
Paper Weight Paper Size Paper Guide Plate
A3 SEF, 11” x 17”
SEF, B4 JIS SEF
Lower the wings Down
128 g/m
2
or thicker
A4 SEF LEF, B5 JIS
SEF LEF
Lower the wings Down
A3 SEF, 11” x 17”
SEF, B4 JIS SEF
Raise the wings fully Up
52.3 g/m
2
-128 g/m
2
A4 SEF LEF, B5 JIS
SEF LEF
Raise the wings to about 45
degrees
Up
A3 SEF, 11” x 17”
SEF, B4 JIS SEF
Raise the wings to about 45
degrees
Down
52.3 g/m
2
or thinner
A4 SEF LEF, B5 JIS
SEF LEF
Raise the wings to about 45
degrees
Down
C262D115.WMF
[A]
[B]
[A]