SERVICE PROGRAM MODE
C262/C265 5-6 SM
5.4 SERVICE PROGRAM MODE
The service program (SP) mode is used to check electrical data, change modes, or
change adjustment values.
CAUTION
Make sure that the data-in LED () is not on before you go into the SP mode.
This LED indicates that some data is coming to the machine. When the LED is
on, wait for the machine to process the data.
5.4.1 ENABLING AND DISABLING SERVICE PROGRAM MODE
NOTE: The Service Program Mode is for use by service representatives only.
If this mode is used by anyone other than service representatives for
any reason, data might be deleted or settings might be changed. In
such case, product quality cannot be guaranteed any more.
Entering SP Mode
1. Press the Clear Modes key.
2. Use the keypad to enter “107”.
D
3. Hold down Clear/Stop for at least 3 seconds.
4. Enter the Service Mode.
Exiting SP Mode
Exit
5. Press Exit on the display panel twice to return to the
copy window.
To Next Page
Loading...
