MASTER FEED SECTION
SM 3-55 C262/C265
Replacement
Adjustment
3.7.21 MASTER EDGE TRIMMING PROCEDURE
Purpose: To even off the leading edge of the master roll, if the edge was not cut
evenly. This happens, for example, after a master misfeed jam (D-Jam).
NOTE: The following procedure cannot be done if a misfeed or SC error
condition was not corrected.
1. Load the master roll in the master making unit.
2. Feed the leading edge manually until it covers the two arrow marks [A].
C262R206.WMF
C262R207.WMF
[A]
To Next Page
Loading...
