MASTER FEED SECTION
C262/C265 3-54 SM
5. Add or remove spacers to adjust the position of the master making unit, if
necessary.
Example: If the value at the leading edge [A] is 32.0 mm and the value at the
trailing edge [B] is 31.8mm ([A] – [B] = 32.0 - 31.8= 0.2), remove the spacer [E]
at the operation side on the master making unit.
NOTE:
1) [A] – [B] = Positive value: Decrease the thickness of spacers at the
operation side.
2) [A] – [B] = Negative value: Decrease the thickness of spacers at the
non-operation side.
3) If one spacer is removed, the master skew is corrected by 0.2 mm.
6. Install the master making unit in the duplicator.
7. Make a new master and checked if the master skew is correct.
To Next Page
Loading...
