Ricoh LDD280 - Machine Operation in Security Mode

SECURITY MODE
SM 6-127 C262/C265
Detailed
Descriptions
6.12.4 MACHINE OPERATION IN SECURITY MODE
These two settings control machine operation.
• The user tool (System Settings – Administrator Tools – Security Option)
• The Security button on the right side of the display panel.
This table shows what the machine does for each set of settings.
User Tool Setting: Normal User Tool Setting: Higher
Security Button: Not
pressed
Additional prints are
possible
The drum can be
removed
The master eject box can
be removed
Not applicable: Security
button always enabled if
‘Higher’ is selected.
Security Button: Pressed Additional prints are not
possible (the
administrator also cannot
do this)
The drum cannot be
removed (the
administrator also cannot
do this)
The master eject box can
be removed
Note: The security button
goes off at the end of the
job, and the above
security features are
disabled. So, to keep your
master secure at the end
of the job, press the
Security button again at
the end of the job.
Additional prints are not
possible (the
administrator also cannot
do this)
The drum cannot be
removed (the
administrator also cannot
do this)
The master eject box
cannot be removed,
except by the
administrator