Ricoh LDD280 - Master Set Sensor, Master Edge Sensor

MASTER FEED SECTION
C262/C265 3-42 SM
[J]: Master feed motor ( x 2,  x 1)
NOTE: Make sure that the end of the master feed motor shaft is flush with the
edge of the pulley [K].
3.7.9 MASTER SET SENSOR, MASTER EDGE SENSOR
• Master making unit ( 3.7.1)
[A]: Master set cover ( x 6)
[B]: Master edge sensor cover ( x 1)
[C]: Master set sensor ( x 1,  x 1)
NOTE: Do the master set sensor adjustment ( 3.7.18) after you install the
new master set sensor.
[D]: Master edge sensor ( x 1,  x 1)
NOTE: Do the master edge sensor adjustment ( 3.7.17) after you install the
new master edge sensor.
C262R047.WMF
C262R049.WMF
[A]
[B]
[C]
[J] [K]
[D]