PAPER FEED
SM 6-79 C262/C265
Detailed
Descriptions
Paper separation pressure
The paper separation pressure, the paper feed pressure and the friction pad that is
used for separation depends on the paper type selected at the operation panel.
When the paper type is changed, the three motors automatically turn to change the
pressure settings and friction pad block.
The top sheet of the paper is separated from the paper stack by the friction
between the paper feed roller [A] and the friction pad [B], and fed to the registration
roller.
The friction pad [B] is mounted on a block [C], and spring pressure is applied to this
block. As explained later, the spring pressure is changed by a dc motor to adjust
the paper separation pressure.
The direction of paper separation pressure motor [D] rotation depends on the
signal from the CPU. The rack [E] moves from side to side, moving the friction pad
base up or down. This changes the spring pressure against the friction pad block.
C262D072.WMF
C262D074.WMF
[A]
[B]
[C]
[E]
[D]
To Next Page
Loading...
