Ricoh LDD280 - 6.8.9 PAPER TABLE ANGLE ADJUSTMENT MECHANISM

PAPER FEED
SM 6-91 C262/C265
Detailed
Descriptions
6.8.9 PAPER TABLE ANGLE ADJUSTMENT MECHANISM
There are two paper table open positions: level, and 15 degrees upward slant.
Normally the paper table is set at the level position.
The 15 degrees upward slant position is used to feed special types of paper, such
as envelopes, which are difficult to feed at the level position. In the slanted position,
the tray capacity is reduced.
As the paper table [A] is lowered from the closed position, the pin on the lever [C]
engages the cutout in the lock bracket [B]. Then, the paper table stops at the level
position.
When the paper table is slightly raised from the level position, the spring plate [D]
pushes the lock bracket [B], and the pin on the lever [C] disengages. This stops the
table at the 15 degrees upward slant position.
C262D081.WMF
C262D082.WMF
[A]
[B]
[C]
[B]
[C]
[D]