PRINTING SECTION
SM 3-105 C262/C265
Replacement
Adjustment
3. Support the rear of the pressure cylinder with the right hand into the side
trapezoid hole (for removing lower wrapping jams), and support the bottom of
the pressure cylinder.
4. Then, put the pressure cylinder into the hole where the drum was. Use both
hands.
5. Install the pressure cylinder, while positioning the thinnest part of the shaft of
the bearing [E] with the clamper cam (the black cam) as shown above. Position
the bearing [E] on the bearing holder.
C262R108.WMF
[E]
To Next Page
Loading...
