PAPER DELIVERY SECTION
C262/C265 3-154 SM
2. Adjust the clearance between the paper pick-off plate [C] and the surface of the
pressure cylinder [D] until it is 0 to 0.8 mm (loosen the 2 screws).
CAUTION: Be sure to do this adjustment after pushing the pressure cylinder up to
the printing section. If the gap is adjusted with the pressure cylinder in
the non-printing section, the paper pick-off plate will damage the
pressure cylinder when the machine pushes the pressure cylinder up to
apply the printing pressure, because the gap will be too small.
C262R118.WMF
0 to 0.8 mm
[C]
[D]
To Next Page
Loading...
