MASTER FEED SECTION
SM 3-35 C262/C265
Replacement
Adjustment
[D]: Loosen the screws that secure the tension bracket.
[E]: Master feed control motor bracket ( x 3, x 1)
[F]: Master feed control motor ( x 2)
NOTE: When you tighten the screws to secure the tension bracket [D], make
sure that the small holes in the rear frame are in line with the small hole
in the tension bracket [G], as shown.
[H]: Master feed control roller bracket ( x 2)
[I]: Clamp tension roller ( x 3)
C262R041.WMF
C262R037.WMF
[D]
[E]
[F]
[H]
[I]
[G]
To Next Page
Loading...
