DRUM SECTION
C262/C265 3-60 SM
[G]: Drum screen ( x 4)
CAUTION:
1) Do not scratch the cloth screen or metal screen.
2) When replacing the cloth screen, spread the screen around the
metal screen while strongly pulling the stay [H]. Adjust the stay so
that it is parallel to the master clamper, then tighten the screws.
3) When installing the new screen, the black sensor patch [I] must be to
the left of the master clamper. (Position the clamper on the top of the
drum, and view from the operation side - refer to the above
illustration.)
4) Make sure that the correct side of the screen is facing up. (Refer to
the illustration below.)
5) Make sure that the stays for securing the cloth screen are positioned
correctly. (Refer to the illustration below.)
After you install a new cloth screen, reset the counter for this part with SP 3-4-1.
C262R056.WMF
C262R058.WMF
[G]
[I]
[H]
[I]
Outside
Inside
To Next Page
Loading...
