MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
SM 3-117 C262/C265
Replacement
Adjustment
Reinstallation Procedure
CAUTION: After you replace the main motor, you must adjust the exit pawl drive
timing. ( 3.12.6 Paper exit pawl drive timing adjustment.) The
following procedure shows the correct time to do this.
1. Make sure that the drum drive disk is in the home position by setting the drum
drive securing tool [A].
NOTE:
1) The tools are available as a service part. The part number is
#C2299000 (three parts as set).
2) If the special tool is not available, align the elongated hole in the
drum drive disk [B] with the shaft [C] below it, as shown.
C262R136.WMF
[A]
[B]
[C]
To Next Page
Loading...
