MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
C262/C265 3-124 SM
7. Remove the 2 springs [G].
8. Remove the pulley bracket [H] ( x 2).
9. Remove the timing belt [I].
10. Remove the gear [J] ( x 2).
11. Loosen the screw [K]
12. Remove the bracket [L] ( x 5, Cord clamp x 2, Bearing x 2).
NOTE:
1) One of the screws is under the main wire harness. Take care not to
damage the wire harness when you remove it
2) When re-installing the bracket [L], make sure to align the cutout in
the bracket [M] with pawl on the torque limiter [N] as shown.
C262R144.WMF
C262R150.WMF
[G]
[H]
[I]
[J]
[L]
[K]
[N]
[M]
To Next Page
Loading...
