MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
SM 3-147 C262/C265
Replacement
Adjustment
5. Set the image shift arm [C] in the home position. To do this, align the hole in
the upper plate [D] with the elongated hole in the image shift arm.
6. Loosen the three screws [E]. The play between the image shift gear and the
drum drive gear is automatically removed.
NOTE: Do not touch the two hexagon bolts [F]. If you do, it can damage the
image shift gear [G].
7. Move the image shift arm [C] up and down and set it in the home position again.
8. Secure the three screws [E].
9. Install the image shifting unit [B] ( x 3, x 2).
10. Loosen the screw [H] and secure it again.
C262R202.WMF
[C]
[D]
[E]
[E]
[F]
[H]
[G]
To Next Page
Loading...
