MASTER FEED
SM 6-43 C262/C265
Detailed
Descriptions
The master is fed an additional 21 mm [D] after the master edge sensor [C] turns
on. It is now caught by the master feed control roller [E] and it stops. This is the
stand-by position for master making.
NOTE:
1) The master set mechanism does not start until the master set sensor [A]
turns on. If the sensor does not turn on, a master set error occurs.
2) A master feed error occurs if the master set sensor does not turn OFF
for more than 5 seconds while the master is fed in reverse.
To Next Page
Loading...
