PRINTING AND PRESSURE CYLINDER
C262/C265 6-108 SM
Pressure Cylinder HP Return Mechanism (Manual Pressure Cylinder
Rotation)
If the operator rotates the pressure cylinder by hand while removing the drum, the
main motor drive also turns. It may not be possible to reinstall the drum, because
the position of the drum drive gear will have changed.
The knob [A] is used to rotate the main motor drive manually. A small plate covers
the knob normally, because it is only for emergency use.
If this happens, the knob can be used to turn the main motor drive. When the arrow
[B] on the indicator disk meets the center division, the drive is at home position.
The drum drive gear is also at home position, and the drum can be reset.
C262D104.WMF
[A]
[B]
Front
Rear
To Next Page
Loading...
