Instrument Function
R&S
®
SMBV100A
126Operating Manual 1407.6062.32 ─ 08
Identification Mode
Selects the way the instrument identification is performed.
"Automatic"
The "IDN String" and the "OPT String" are set automatically for the
instrument select with the parameter "Language".
"User Defined"
Enables the selection of user definable "IDN String" and "OPT String"
for the instrument selected with the parameter "Language".
SCPI command:
:SYSTem:IDENtification on page 714
Set to default
Overwrites the user-defined *IDN and *OPT strings with default strings.
The default strings vary depending on the selected emulation mode (Language)
SCPI command:
n.a.
IDN String
Indicates the identification string of the instrument when queried with the common com-
mand *IDN?.
In addition to the preset values, a user defined identification string can be entered, e.g.
to provide individual identification for each generator, like 'MY_R&S SMBV' for instance.
SCPI command:
*IDN?
OPT String
Indicates the option string of the instrument as queried with common command *OPT?.
If a "User Defined" Identification Mode is selected, a user defined option string can be
created, additionally to the automatically created one.
SCPI command:
*OPT?
GPIB channel address
Sets the GPIB address of the instrument.
SCPI command:
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess on page 707
RS232 using USB adapter
Requires a USB serial adapter (recommended extra, see data sheet)
Sets the parameters of the serial interface.
Either a RS232 interface or a Bluetooth connection can be used for remote control via
the serial interface. The settings are effective for both interfaces (see also chap-
ter 5.2.3.16, "Security", on page 128).
SCPI command:
:SYSTem:COMMunicate:SERial:BAUD on page 710
:SYSTem:COMMunicate:SERial:PARity on page 711
:SYSTem:COMMunicate:SERial:SBITs on page 711
General Instrument Settings
To Next Page
Loading...
