Instrument Function
R&S
®
SMBV100A
296Operating Manual 1407.6062.32 ─ 08
Enable this function to accelerate the saving process by saving only the settings with
values different to the default ones.
Note: This function is not affected by the "Preset" function.
SCPI command:
[:SOURce<hw>]:BB:DM:SETTing:STORe:FAST on page 582
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:STORe:FAST on page 534
refer to the description of frimware options for the syntax of the corresponding SCPI
commands
Data Source
The data source is selected and set in the "Data Source" section. The parameters offered
depend on the data source selected. The More button opens a submenu for calling the
data editor and the file manager.
Data Source - Digital Modulation
Selects the data source (see chapter 5.8.2, "Data and Signal Sources in Base-
band", on page 274).
You may choose from the following data sources:
"All 0, All 1"
0 data or 1 data is internally generated.
"PRBS, PRBS
Type"
PRBS data in accordance with the IUT-T with period lengths between
29-1 and 223-1 are internally generated.
The length is selected in the "PRBS Type" input box.
SCPI command:
[:SOURce<hw>]:BB:DM:PRBS[:LENGth] on page 549
"Pattern"
A user-definable bit pattern with a maximum length of 64 bits is inter-
nally generated.
The bit pattern is defined in the "Pattern" input box.
Baseband Signal - Baseband Block
To Next Page
Loading...
