Instrument Function
R&S
®
SMBV100A
297Operating Manual 1407.6062.32 ─ 08
"Data List ...,
Select Data"
Data lists will be used.
Data lists can be generated internally in the data editor or externally.
Data lists are selected in the "File Select" window, which is called by
means of the "Select Data" button.
The "File" "Manager" is used to transmit external data lists to the R&S
Signal Generator, and can be called within every "File" Select window
by means of the "File" "Manager" button.
SCPI command:
[:SOURce<hw>]:BB:DM:DLISt:SELect on page 578
SCPI command:
[:SOURce<hw>]:BB:DM:SOURce on page 550
List Management - Digital Modulation
Calls the menu for managing data and control lists (see "List Manage-
ment" on page 305).
SCPI command:
n.a.
Standard, Symbol Rate, Coding
The middle part of the menu is used for selecting the standard, the symbol rate and the
coding.
Set acc. to Standard - Digital Modulation
Selects a standard.
After selection, modulation parameters "Modulation Type", "Symbol Rate", "Filter" and
"Coding" are automatically set in accordance with the standard.
If one of these parameters is subsequently altered, the display changes to User. The User
setting can be saved to a file so that it can be recalled at some later time ("Save/Recall
User.." button).
The following table shows the standards that are available, together with the associated
settings of the modulation parameters.
Baseband Signal - Baseband Block
To Next Page
Loading...
