Rohde & Schwarz SMBV100A - Page 633

Remote Control Commands
R&S
®
SMBV100A
616Operating Manual 1407.6062.32 ─ 08
In the following command examples, the files are stored in the default directory.
The amplitude can also be linearized automatically by means of a R&S NRP power sen-
sor connected to the generator output signal. With the aid of the command [:
SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe, a list
with correction values for external test assemblies can be automatically determined, e.g.
for compensating the frequency response of cables. The correction values can be
acquired any time irrespective of the modulation settings of the generator.
[:SOURce]:CORRection:CSET:CATalog...........................................................................616
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency....................................................617
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency:POINts.........................................617
[:SOURce<hw>]:CORRection:CSET:DATA:POWer...........................................................617
[:SOURce<hw>]:CORRection:CSET:DATA:POWer:POINts................................................618
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe........................618
[:SOURce]:CORRection:CSET:DELete............................................................................618
[:SOURce<hw>]:CORRection:DEXChange:AFILe:CATalog................................................619
[:SOURce<hw>]:CORRection:DEXChange:AFILe:EXTension.............................................619
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SELect..................................................620
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:COLumn................................620
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:DECimal................................621
[:SOURce<hw>]:CORRection:DEXChange:EXECute.........................................................621
[:SOURce<hw>]:CORRection:DEXChange:MODE............................................................621
[:SOURce<hw>]:CORRection:DEXChange:SELect............................................................622
[:SOURce<hw>]:CORRection:CSET[:SELect]...................................................................622
[:SOURce<hw>]:CORRection[:STATe].............................................................................623
[:SOURce<hw>]:CORRection:VALue...............................................................................623
[:SOURce]:CORRection:CSET:CATalog?
The command requests a list of user correction tables. The individual lists are separated
by commas.
The lists are stored with the fixed file extensions *.uco in a directory of the user's choice.
The directory applicable to the commands is defined with the command
MMEMory:CDIR.
Return values:
<Catalog> string
Example:
MMEM:CDIR '/var/smbv/Lists/ucor'
selects the directory for the user correction files.
CORR:CSET:CAT?
queries which correction tables are available.
Response:UCOR1,UCOR2,UCOR3
the correction tables UCOR1, UCOR2 and UCOR3 are available.
Usage: Query only
SOURce Subsystem