Roland SonicCell User Manual

100
Using the SonicCell in Patch Mode
*1 Note values
Tone Delay Time
0127,
Note (* 1)
Specifies the time from when the key is pressed (or if the Delay Mode pa-
rameter is set to “OFF-N” or “OFF-D,” the time from when the key is re-
leased) until when the tone will sound.
Tone Delay Time specifies the beat length for the synchronized tempo when
the tempo that specifies the elapsed time until the tone is sounded (Patch
Tempo) is synchronized with the tempo set in an external MIDI sequencer.
(Example)
For a tempo of 120 (120 quarter notes occur in 1 minute (60 seconds))
(half note) 1 second (60/60= 1 (second))
(quarter note) 0.5 seconds (60/120= 0.5 (seconds))
(eighth note) 0.25 seconds (60/240= 0.25 (seconds))
Tone Coarse Tune ★ -48–+48
Adjusts the pitch of the tone’s sound up or down in semitone steps (+/-4 oc-
taves).
★ You can use matrix control to modify this. (p. 95)
Tone Fine Tune ★ -50–+50
Adjusts the pitch of the tone’s sound up or down in 1-cent steps (+/-50
cents).
* One cent is 1/100th of a semitone.
★ You can use matrix control to modify this. (p. 95)
Random Pch Dpth
(Random Pitch Depth)
0–9,
10–90,
100–1200
This specifies the width of random pitch deviation that will occur each time
a key is pressed. If you do not want the pitch to change randomly, set this
to “0.” These values are in units of cents (1/100th of a semitone).
Pitch Keyfollow -200–+200
This specifies the amount of pitch change that will occur when you play a
key one octave higher (i.e., 12 keys upward on the keyboard).
If you want the pitch to rise one octave as on a conventional keyboard, set
this to “+100.” If you want the pitch to rise two octaves, set this to “+200.”
Conversely, set this to a negative value if you want the pitch to fall. With a
setting of “0,” all keys will produce the same pitch.
Bend Range Up 0–+48
Specifies the degree of pitch change in semitones when the Pitch Bend lever
is all the way right. For example, if this parameter is set to “12,” the pitch
will rise one octave when the pitch bend lever is moved to the right-most po-
sition.
Bend Range Down 0– -48
Specifies the degree of pitch change in semitones when the Pitch Bend lever
is all the way left. For example if this is set to “-48” and you move the pitch
bend lever all the way to the left, the pitch will fall 4 octaves.
Parameter
Value Explanation
C4C3C2C1 C5 C6 C7
0
+50
+100
+200
-50
-100-200
Key
Pitch
Double note
Dotted whole note
Dotted half note
Dotted thirty-second note
Whole note
Double-note triplet
Sixteenth-note triplet
Thirty-second note
Sixty-fourth-note triplet Sixty-fourth note Thirty-second-note triplet
Dotted eighth noteQuarter-note tripletEighth note
Half-note tripletQuarter note
Dotted quarter note
Whole-note triplet
Half note
Sixteenth note
Eighth-note triplet
Dotted sixteenth note
SonicCell_e.book 100 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English