Roland SonicCell - Specifies How MFX3 will be Used (MFX3 Location Screen); Saving the MFX3 Settings

149
Input/output and effect settings (In/Out Routing)
If you’ve edited the MFX3 effect type or parameter values, those settings will be saved as settings of the currently selected
performance .
To save the settings, from the MFX3 screen, press [MENU] to access the menu screen, and then choose “Write” (Performance Write).
(Performance Write: p. 73)
* In/Out routing settings are saved as system settings. (System Write: p. 150)
Specifies how MFX3 will be used (MFX3 Location screen)
Parameter
Value Explanation
Type
TG, Input FX
Specifies how MFX3 will be used.
TG: MFX3 will be used as the effect applied to the SonicCell’s
tone generator (TG).
Input FX: MFX3 will be connected following the input effect. You’ll be
able to use MFX3 on the audio input via INPUT and USB.
If this is set to Input FX, you won’t be able to use MFX3 on the
performance.
Editing the MFX3 settings
If you’ve selected the Input FX setting, the In/Out Routing screen will show
“F3.” By choosing “F3” you can move to the MFX3 screen and edit the
MFX3 settings. However, this will edit the MFX3 settings of the currently se-
lected performance.
Saving the MFX3 settings
This screen won’t appear in Patch mode.
USB
Audio
INPUT
Input
Effect
MFX1
MFX3
MFX2
Tone
Generator
(TG)
USB
Audio
INPUT
Input
Effect
MFX1
MFX3
MFX2
Tone
Generator
(TG)
SonicCell_e.book 149 ページ ２００７年８月９日 木曜日 午後９時１７分