60
Using the SonicCell in Performance Mode
This specifies the mode of the MIDI sound generator.
The current mode is highlighted.
1.
Turn [CURSOR/VALUE] to move the cursor, and press
[CURSOR/VALUE] to confirm your choice of mode.
If you select “Performance” and press [CURSOR/VALUE],
the following screen will appear.
fig.disp-PerformanceTop
In the Perform MIDI Filter screen you can edit the following parameters for each part.
Switching the sound mode (Sound Mode screen)
Specifying the recommended performance tempo
(Performance General screen)
Parameter
Value Explanation
Recommend Tempo
20–250
If you want the system tempo to change when you switch Performances, specify the
tempo that will follow this change.
This setting is valid when the Seq Tempo Override is “ON.”
In order to enable this setting, turn on the Tempo Override (p. 177).
MIDI-related settings (Perform MIDI Filter screen)
Parameter
Value Explanation
PC
(Receive Program Change Switch)
_, O
Determines, on an individual MIDI channel basis, whether MIDI program
change messages will be received (O) or not received (_).
BS
(Receive Bank Select Switch)
_, O
Determines, on an individual MIDI channel basis, whether MIDI bank select
messages will be received (O) or not received (_).
PB
(Receive Pitch Bend Switch)
_, O
Determines, on an individual MIDI channel basis, whether MIDI pitch bend
messages will be received (O) or not received (_).
PA
(Receive Polyphonic Key Pressure Switch)
_, O
Determines, on an individual MIDI channel basis, whether MIDI polyphonic
key pressure messages will be received (O) or not received (_).
CA
(Receive Channel Pressure Switch)
_, O
Determines, on an individual MIDI channel basis, whether MIDI channel pres-
sure messages will be received (O) or not received (_).
SonicCell_e.book 60 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
