USER‘S GUIDE
46
Installing the Wave Expansion Board
Two Wave Expansion Boards (SRX series; sold separately) can be installed in the SonicCell.
Waveform data, patches and rhythm sets are stored on the Wave Expansion Board, so you can increase
the number of available sounds by installing the board in the SonicCell.
●
To avoid the risk of damage to internal components that can be caused by static electricity, please carefully
observe the following whenever you handle the board.
❍
Before you touch the board, always first grasp a metal object (such as a water pipe), so you are sure that
any static electricity you might have been carrying has been discharged.
❍
When handling the board, grasp it only by its edges. Avoid touching any of the electronic components or
connectors.
●
When removing the screws, you must use the included Allen wrench. If you use the wrong tool, you risk
damaging the screw head.
fig.30-001-e
●
To remove a screw, rotate the Allen wrench counter-clockwise. To tighten the
screws, rotate the Allen wrench clockwise.
●
When you tighten the screws, take care not to overtighten them. Doing so may
cause the screw head to be stripped, allowing the Allen wrench to turn uselessly.
●
When installing Wave Expansion Boards, remove only the specified screws.
●
Be careful that the screws you remove do not drop into the interior of the SonicCell.
●
Do not leave the cover removed. After installation of the Wave Expansion Boards is complete, be sure to
replace the cover.
●
Be careful not to cut your hand on the opening for installing the board.
911
●
Do not touch any of the printed circuit pathways or connection terminals.
912
●
Never use excessive force when installing a circuit board. If it doesn’t fit properly on the first attempt, remove
the board and try again.
913
●
When circuit board installation is complete, double-check your work.
NOTE
Installing a Wave Expansion Board increases the patches and drum sets for Parts, but the num-
ber of Parts doesn’t change. The Wave Expansion Board can be installed by removing the top
cover.
Cautions When Installing an Wave
Expansion Board
tightenloosen
SonicCell_e.book 46 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
