114
Using the SonicCell in Patch Mode
Controller-related settings (Patch Ctrl screen)
Parameter
Value Explanation
Tone Env (Envelope) Mode
NO-SUS,
SUSTAIN
When a loop waveform (p. 97) is selected, the sound will normally continue
as long as the key is pressed. If you want the sound to decay naturally even
if the key remains pressed, set this to “NO-SUS.”
If a one-shot type Wave (p. 97) is selected, it will not sustain even if this
parameter is set to “SUSTAIN.”
Tone Rx Bender
(Tone Receive Pitch Bend
Switch)
OFF, ON
For each tone, specify whether MIDI Pitch Bend messages will be received
(ON), or not (OFF).
Tone Rx Xpr
(Tone Receive Expression
Switch)
OFF, ON
For each tone, specify whether MIDI Expression messages will be received
(ON), or not (OFF).
Tone Rx Hold-1
(Tone Receive Hold Switch)
OFF, ON
For each tone, specify whether MIDI Hold-1 messages will be received
(ON), or not (OFF).
If “NO-SUS” is selected for Tone Env Mode, this setting will have no effect.
Tone Rx Pan Mode
(Tone Receive Pan Mode)
CONT, K-ON
For each tone, specify how pan messages will be received.
CONT:
Whenever Pan messages are received, the stereo position of
the tone will be changed.
K-ON:
The pan of the tone will be changed only when the next note is
played. If a pan message is received while a note is sounding,
the panning will not change until the next key is pressed.
The channels cannot be set so as not to receive Pan messages.
Tone Redamper Sw (Switch)
OFF, ON
You can specify, on an individual tone basis, whether or not the sound will
be held when a Hold 1 message is received after a key is released, but be-
fore the sound has decayed to silence. If you want to sustain the sound, set
this “ON.” When using this function, also set the Rx Hold-1 “ON.” This func-
tion is effective for piano sounds.
SonicCell_e.book 114 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
