Roland SonicCell User Manual

122
Using the SonicCell in Patch Mode
You can use your keyboard playing dynamics to control the
four waveforms assigned to the rhythm tone. These settings are
collectively called the “Wave Mix Table (WMT).”
■ Rhythm Pitch screen......................................................................................................
Specifying how a rhythm tone will be heard (Rhythm WMT screen)
Parameter
Value Explanation
WMT Velo Ctrl
(WMT Velocity Control
Switch)
OFF, ON,
RANDOM
WMT Velocity Control determines whether a different rhythm tone is played (ON)
or not (OFF) depending on the force with which the key is played (velocity).
When set to “RANDOM,” the rhythm set’s constituent rhythm tones will sound ran-
domly, regardless of any Velocity messages.
Velo Fade Lower
(Velocity Fade Width Lower)
0–127
This determines what will happen to the tone’s level when the tone is played at a
velocity lower than its specified velocity range. Higher settings produce a more
gradual change in volume. If you want notes played outside the specified key ve-
locity range to not be sounded at all, set this to “0.”
Velo (Velocity) Range Lower 1–UPPER
This sets the lowest velocity at which the waveform will sound. Make these settings
when you want different waveforms to sound in response to notes played at differ-
ent strengths.
Velo (Velocity) Range Upper LOWER–127
This sets the highest velocity at which the waveform will sound. Make these settings
when you want different waveforms to sound in response to notes played at differ-
ent strengths.
If you attempt to set the Lower velocity limit above the Upper, or the Upper below
the Lower, the other value will automatically be adjusted to the same setting.
Velo Fade Upper
(Velocity Fade Width Upper)
0–127
This determines what will happen to the tone’s level when the tone is played at a
velocity greater than its specified velocity range. Higher settings produce a more
gradual change in volume. If you want notes played outside the specified key ve-
locity range to not be sounded at all, set this to “0.”
Pitch-related rhythm tone settings (Rhythm Pitch/Rhythm Pch Env screen)
Parameter
Value Explanation
Tone Coarse Tune
(Rhythm Tone Coarse Tune)
C-1–G9
Selects the pitch at which a rhythm tone sounds.
Set the coarse tuning for Waves comprising the rhythm tones with the
Wave Coarse Tune (p. 121).
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Velocity
SonicCell_e.book 122 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English