123
Using the SonicCell in Patch Mode
■
Rhythm Pch Env screen .................................................................................................
Tone Fine Tune
(Rhythm Tone Fine Tune)
-50–+50
Adjusts the pitch of the rhythm tone’s sound up or down in 1-cent steps (+/
-50 cents).
* One cent is 1/100th of a semitone.
Set the fine tuning for Waves comprising the rhythm tones with the Wave
Fine Tune (p. 121).
Random Pch Dpth
(Random Pitch Depth)
0–9,
10–90,
100–1200
This specifies the width of random pitch deviation that will occur each time
a key is pressed. If you do not want the pitch to change randomly, set this
to “0.” These values are in units of cents (1/100th of a semitone).
Parameter
Value Explanation
P-Env Depth
(Pitch Envelope Depth)
-12–+12
Adjusts the effect of the Pitch Envelope. Higher settings will cause the pitch
envelope to produce greater change. Negative (-) settings will invert the
shape of the envelope.
P-Env V-Sens
(Pitch Envelope Velocity Sensi-
tivity)
-63–+63
Keyboard playing dynamics can be used to control the depth of the pitch
envelope. If you want the pitch envelope to have more effect for strongly
played notes, set this parameter to a positive (+) value. If you want the pitch
envelope to have less effect for strongly played notes, set this to a negative
(-) value.
P-Env T1 V-Sens
(Pitch Envelope Time 1 Veloci-
ty Sensitivity)
-63–+63
This allows keyboard dynamics to affect the Time 1 of the Pitch envelope. If
you want Time 1 to be speeded up for strongly played notes, set this param-
eter to a positive (+) value. If you want it to be slowed down, set this to a
negative (-) value.
P-Env T4 V-Sens
(Pitch Envelope Time 4 Veloci-
ty Sensitivity)
-63–+63
Use this parameter when you want key release speed to affect the Time 4
value of the pitch envelope. If you want Time 4 to be speeded up for quickly
released notes, set this parameter to a positive (+) value. If you want it to be
slowed down, set this to a negative (-) value.
P-Env Time 1–4
(Pitch Envelope Time 1–4)
0–127
Specify the pitch envelope times (Time 1–Time 4). Higher settings will result
in a longer time until the next pitch is reached. (For example, Time 2 is the
time over which the pitch changes from Level 1 to Level 2.)
P-Env Level 0–4
(Pitch Envelope Level 0–4)
-63–+63
Specify the pitch envelope levels (Level 0–Level 4). It determines how much
the pitch changes from the reference pitch (the value set with Coarse Tune
or Fine Tune on the Pitch screen) at each point. Positive (+) settings will cause
the pitch to be higher than the standard pitch, and negative (-) settings will
cause it to be lower.
Parameter
Value Explanation
T1 T2 T3 T4
L3
L4
L2
L1
L0
Note off
Pitch
Time
Note on
T: Time L: Level
SonicCell_e.book 123 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
