142
Inputting sound from an external device (INPUT)
1.
Press [INPUT] so its indicator is lit.
The Input screen will appear.
fig.disp-Input-top01
2.
Turn [CURSOR/VALUE] to move the cursor to the
parameter you want to edit.
3.
Press [CURSOR/VALUE] to highlight the value.
fig.disp-Input-top02
4.
Turn [CURSOR/VALUE] to edit the value.
5.
When you’ve finished editing the value, press [CURSOR/
VALUE].
To save the setting, press [MENU] to access the menu screen,
and choose “Write” (System Write) to execute the Write
operation (System Write: p. 150).
Basic operation
Parameter
Value Explanation
Phantom Power
OFF, ON
Turns phantom power on/off.
Turn this “ON” if you’ve connected a phantom-powered condenser mic to
the MIC INPUT jack.
• You must turn phantom power “OFF” unless a condenser mic that
requires phantom power is connected. Supplying phantom power to a
dynamic mic will cause malfunctions. For details on mic specifications,
refer to the owner’s manual for the mic you’re using.
• Before you switch phantom power on/off, you must turn the front panel
[VOLUME] knob to “0.” If you turn phantom power on/off with the
volume raised, high-volume noise will be produced, possibly damaging
your amp or speakers.
• When you turn the power on, the phantom power will always be OFF.
Assign
To COM+Output,
To COM, To Input FX
Specifies where the input signal is to be sent.
To COM+ Output:
Sent to computer and OUTPUT.
To COM:
Output to the computer.
INPUT
OUTPUT
Computer
Input
Effect
INPUT
OUTPUT
Computer
Input
Effect
SonicCell_e.book 142 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
