107
Using the SonicCell in Patch Mode
■
Patch TVA Env screen....................................................................................................
Parameter
Value Explanation
A-Env T1 V-Sens
(TVA Envelope Time 1 Velocity
Sensitivity)
-63–+63
This allows keyboard dynamics to affect the Time 1 of the TVA envelope. If
you want Time 1 to be speeded up for strongly played notes, set this param-
eter to a positive (+) value. If you want it to be slowed down, set this to a
negative (-) value.
A-Env T4 V-Sens
(TVA Envelope Time 4 Velocity
Sensitivity)
-63–+63
The parameter to use when you want key release speed to control the Time
4 value of the TVA envelope. If you want Time 4 to be speeded up for quick-
ly released notes, set this parameter to a positive (+) value. If you want it to
be slowed down, set this to a negative (-) value.
A-Env Time KF
(TVA Envelope Time Keyfol-
low)
-100–+100
Use this setting if you want the TVA envelope times (Time 2–Time 4) to be
affected by the keyboard location. Based on the TVA envelope times for the
C4 key (center C), positive (+) settings will cause notes higher than C4 to
have increasingly shorter times, and negative (-) settings will cause them to
have increasingly longer times. Larger settings will produce greater change.
A-Env Time1–4
★
(TVA Envelope Time 1–4)
0–127
Specify the TVA envelope times (Time 1– Time 4). Higher settings will length-
en the time until the next volume level is reached. (For example, Time 2 is
the time over which Level 1 will change to Level 2.)
★
You can use matrix control to modify this. (p. 95)
A-Env Level1–3
(TVA Envelope Level 1–3)
0–127
Specify the TVA envelope levels (Level 1–Level 3). These settings specify how
the volume will change at each point, relative to the standard volume (the
Tone Level value specified in the TVA screen).
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
T1 T2 T3 T4
L3
L1
L2
Note off
Level
Time
Note on
T: Time L: Level
SonicCell_e.book 107 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
