Roland SonicCell User Manual

181
System Settings
In Performance mode or Patch mode, select “M” in the Effect
Routing screen to access the Mastering Effect screen.
It has independent high, mid, and low ranges. Independently
for the high-frequency, mid-frequency, and low-frequency
regions, this compresses any sounds that exceed the specified
level, making the volume more consistent.
When you procedure your own original audio CD, this lets
you master at an optimized level.
Mastering effect settings apply to the entire SonicCell. These
settings are not for individual patches or performances.
■ Menu screen.................................................................................................................
From the Mastering Effect screen, you can press [MENU] to access the Mastering Type
screen.
Press [MENU] once again to return to the Mastering Effect screen.
Editing the mastering effect (Mastering Effect screen)
Parameter
Value Explanation
Split Freq L
(Split Frequency Low)
200–800 Hz
Frequency at which the low-frequency (Low) and mid-frequency (Mid) bands are split.
Split Freq H
(Split Frequency High)
2000–8000
Hz
Frequency at which the high-frequency (High) and mid-frequency (Mid) bands are
split.
Low/Mid/High Attack 0–100 ms
Time from when the volume goes up the threshold level until the compressor effect
applies.
Low/Mid/High Release 50–5000 ms
Time from when the volume falls below the threshold level until the compressor effect
no longer applies.
Low/Mid/High Threshold -36–0 dB
Specifies the volume levels at
which compression will begin
for the low-frequency (Low), mid-
frequency (Mid), and high-fre-
quency (High) ranges.
About THRESHOLD and RATIO
As shown in the diagram below, these parameters
determine how the volume is to be compressed.
Low/Mid/High Ratio
1.00:1–
INF:1
(INF: infinity)
Specifies the compression ratios
for the low-frequency (Low), mid-
frequency (Mid), and high-fre-
quency (High) ranges.
Low/Mid/High Level 0–24 dB
Specifies the output volume for the low-frequency (Low), mid-frequency (Mid), and
high-frequency (High) ranges.
1:1
2:1
4:1
INF:1
THRESHOLD
Input Level
Output Level
RATIO
Parameter
Explanation
Write
(System Write)
Saves the current settings as user settings. (p. 150).
Hard Comp, Soft Comp, Lo Boost,
Mid Boost, Hi Boost
Recalls preset settings of the type you select.
User Recalls user settings you’ve saved.
SonicCell_e.book 181 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English