Roland SonicCell User Manual

USER‘S GUIDE
40
Recording a Mic or Guitar
(USB/Audio Interface)
■ Connections
fig.setsuzoku-Input.eps
INPUT
LINE (R)
LINE (L)
GUITAR (Hi-Z)
MIC
MIC
(DC 48 V/10mA)
OUTPUT
USB COMPUTER
USB cable
Keyboard
To USB Connector
of Computer
Dynamic Mic
Acoustic Guitar etc.
Condenser Mic
Guitar
Computer
Set the INPUT LEVEL knob to “MIN”
before making connections
Monitor Amplifier etc.
NOTE
* To prevent malfunction and/or damage to speakers or other devices, always turn down the vol-
ume, and turn off the power on all devices before making any connections.
* When connection cables with resistors are used, the volume level of equipment connected to the
inputs (INPUT) may be low. If this happens, use connection cables that do not contain resistors.
* Howling could be produced depending on the location of microphones relative to speakers. This
can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
fig.XLR/TRSJack.eps
* This instrument is equipped with bal-
anced (XLR/TRS) type jacks. Wiring
diagrams for these jacks are shown
below. Make connections after first
checking the wiring diagrams of
other equipment you intend to connect.
SonicCell_e.book 40 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English