Roland SonicCell User Manual

105
Using the SonicCell in Patch Mode
■ Patch TVA screen..........................................................................................................
F-Env Time1–4 ★
(TVF Envelope Time 1–4)
0–127
Specify the TVF envelope times (Time 1–Time 4). Higher settings will length-
en the time until the next cutoff frequency level is reached. (For example,
Time 2 is the time over which Level 1 will change to Level 2.)
★ You can use matrix control to modify this. (p. 95)
F-Env Level0–4
(TVF Envelope Level 0–4)
0–127
Specify the TVF envelope levels (Level 0–Level 4). These settings specify how
the cutoff frequency will change at each point, relative to the standard cutoff
frequency (the cutoff frequency value specified in the TVF screen).
Parameter
Value Explanation
T1 T2 T3 T4
L3
L1
L0
L2 L4
Note off
Cutoff
Frequency
Time
Note on
T: Time L: Level
TVA settings (Patch TVA/Patch TVA Env screen)
Parameter
Value Explanation
Tone Level ★
0–127
Sets the volume of the tone. This setting is useful primarily for adjusting the
volume balance between tones.
★ You can use matrix control to modify this. (p. 95)
Level V-Curve
(TVA Level Velocity Curve)
FIX, 1–7
You can select from seven curves that determine how keyboard playing
strength will affect the volume. If you do not want the volume of the tone to
be affected by the force with which you play the key, set this to “FIX.”
Level V-Sens
(TVA Level Velocity Sensitivity)
-63–+63
Set this when you want the volume of the tone to change depending on the
force with which you press the keys. Set this to a positive (+) value to have
the changes in tone volume increase the more forcefully the keys are played;
to make the tone play more softly as you play harder, set this to a negative
(-) value.
If you wish to make adjustments to the entire patch while maintaining the
relative values of Level V-Sens among tones, adjust the Velocity Sens (p.
91). However, this setting is shared by the Cutoff V-Sens (p. 103).
Bias Level -100–+100
Adjusts the angle of the volume change that will occur in the selected Bias
Direction. Larger settings will produce greater change. Negative (-) values
will invert the change direction.
Bias Position C-1–G9
Specifies the key relative to which the volume will be modified.
1234567
SonicCell_e.book 105 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English