106
Using the SonicCell in Patch Mode
Bias Direction
LOWER, UPPER,
LO&UP, ALL
Selects the direction in which change will occur starting from the Bias Posi-
tion.
LOWER:
The volume will be modified for the keyboard area below the
Bias Point.
UPPER:
The volume will be modified for the keyboard area above the
Bias Point.
LO&UP:
The volume will be modified symmetrically toward the left and
right of the Bias Point.
ALL:
The volume changes linearly with the bias point at the center.
Bias
Bias causes the volume to be affected by the keyboard position. This is useful for changing volume through keyboard position (pitch)
when playing acoustic instruments.
Tone Pan
★
L64–0–63R
Sets the pan of the tone. “L64” is far left, “0” is center, and “63R” is far
right.
★
You can use matrix control to modify this. (p. 95)
Pan Keyfollow
-100–+100
Use this parameter if you want key position to affect panning. Positive (+)
settings will cause notes higher than C4 key (center C) to be panned increas-
ingly further toward the right, and negative (-) settings will cause notes high-
er than C4 key (center C) to be panned toward the left. Larger settings will
produce greater change.
Random Pan Depth
0–63
Use this parameter when you want the stereo location to change randomly
each time you press a key. Higher settings will produce a greater amount of
change.
Alter (Alternate) Pan Depth
L63–63R
This setting causes panning to be alternated between left and right each time
a key is pressed. Higher settings will produce a greater amount of change.
“L” or “R” settings will reverse the order in which the pan will alternate be-
tween left and right. For example if two tones are set to “L” and “R” respec-
tively, the panning of the two tones will alternate each time they are played.
When any value from Type “2”–”10” is selected for the Str Type (p. 93) in
the Pan Keyfollow, Random Pan Depth, Alter Pan Depth settings, the output
of tones 1 and 2 are joined in tone 2, and the output of tones 3 and 4 are
joined in tone 4. For this reason, tone 1 will follow the settings of tone 2,
and tone 3 will follow the settings of tone 4.
Parameter
Value Explanation
C-1 G9
+
0
–
C-1 G9
+
0
–
LOWER UPPER
Bias Position
Level Level
Key Key
Bias Position
C-1 G9
+
0
–
C-1 G9
+
0
–
+
0
–
+
0
–
LO&UP
ALL
Level Level
Key
Key
Bias Position Bias Position
C4C3C2C1 C5 C6 C7
0
+50
+100
+200
-50
-100-200
Key
Pitch
SonicCell_e.book 106 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
