Using the SonicCell as a MIDI Sound Module
25
■ USER’S GUIDE
Adjusting the Attack
fig.dispTVAEnv.eps
Turn [CURSOR/VALUE] to move the cursor to “A-Env Time1.”
Press [CURSOR/VALUE].
The value will be highlighted.
Turn [CURSOR/VALUE] to change the value, then press [CUR-
SOR/VALUE].
When you change the value, the graph in the lower part of the
screen will also change.
If you press [EXIT] you’ll return to the previous screen.
fig.disp-TVAEnvT1h1.eps
•
To make the sound begin immediately when you press a
key
➝
Set “A-Env Time1” to a low value
fig.disp-TVAEnvT1h2.eps
•
To make the sound begin slowly when you press a key
➝
Set “A-Env Time1” to a high value
Adjusting the Release
fig.dispTVAEnvT4.eps
Turn [CURSOR/VALUE] to move the cursor to “A-Env Time4.”
Press [CURSOR/VALUE].
The value will be highlighted.
Turn [CURSOR/VALUE] to change the value, then press [CUR-
SOR/VALUE].
When you change the value, the graph in the lower part of the
screen will also change.
If you press [EXIT] you’ll return to the previous screen.
fig.disp-TVAEnvT4h1.eps
•
To make the sound stop immediately when you release a
key
➝
Set “A-Env Time4” to a low value
fig.disp-TVAEnvT4h2.eps
•
To make the sound linger after you release a key
➝
Set “A-Env Time1” to a high value
For details on amp envelope, refer to p. 107 .
If you want to save the patch you modified, refer to p. 116 .
4
5
6
T4 (when you release a key)
7
8
9
MEMO
SonicCell_e.book 25 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
