Roland SonicCell User Manual

103
Using the SonicCell in Patch Mode
Resonance ★ 0–127
Emphasizes the portion of the sound in the region of the cutoff frequency, adding
character to the sound. Excessively high settings can produce oscillation, causing
the sound to distort.
To edit the overall patch while preserving the relative differences in the
Resonance values set for each tone, set the Resonance Offset (p. 91).
★ You can use matrix control to modify this. (p. 95)
Cutoff Freq KF
(Cutoff Frequency
keyfollow)
-200–+200
Use this parameter if you want the cutoff frequency to change according to the
key that is pressed. Relative to the cutoff frequency at the C4 key (center C), pos-
itive (+) settings will cause the cutoff frequency to rise for notes higher than C4,
and negative (-) settings will cause the cutoff frequency to fall for notes higher than
C4. Larger settings will produce greater change.
Cutoff V-Curve
(Cutoff Frequency Velocity
Curve)
FIXED, 1–7
Selects one of the following seven curves that determine how keyboard playing
dynamics (velocity) influence the cutoff frequency. Set this to “FIXED” if you don’t
want the Cutoff frequency to be affected by the keyboard velocity.
Cutoff V-Sens
(Cutoff frequency Velocity
Sensitivity)
-63–+63
Use this parameter when changing the cutoff frequency to be applied as a result
of changes in playing velocity. If you want strongly played notes to raise the cutoff
frequency, set this parameter to positive (+) settings. If you want strongly played
notes to lower the cutoff frequency, use negative (-) settings.
To edit the overall patch while preserving the relative differences in the Cutoff V-
Sens values set for each tone, set the Velocity Sens (p. 91). However, this setting
is shared by the Level V-Sens (p. 105).
Resonance V-Sens
(Resonance Velocity Sensi-
tivity)
-63–+63
This allows keyboard velocity to modify the amount of Resonance. If you want
strongly played notes to have a greater Resonance effect, set this parameter to
positive (+) settings. If you want strongly played notes to have less Resonance, use
negative (-) settings.
Parameter
Value Explanation
LPF BPF HPF PKG
parameter value
Level
Cutoff frequency
Frequency
High
Low
C4C3C2C1 C5 C6 C7
0
+50
+100
+200
-50
-100-200
0
-1
-2
+1
+2
Cutoff frequency
(Octave)
Key
1234567
SonicCell_e.book 103 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English